BSYJG - DRY CLEANING SOLVENT
- MSDS: BSYJG
- Manufacturer: VAN WATERS AND ROGERS INC SUB OF UNIVAR
- Product Name: DRY CLEANING SOLVENT
- National Stock Number: 6850-00-110-4498
Product Identification
Product ID:DRY CLEANING SOLVENT
MSDS Date:01/01/1992
FSC:6850
NIIN:00-110-4498
MSDS Number: BSYJG
Responsible Party
KIRKLAND, WA 98033
US
Emergency Phone: 714-683-5165/800-424-9300(CHEMTREC)
Info Phone: 206-889-3712
Preparer: C.A. EISENHARD
Cage: 0STM5
Contractor
Telephone: 425-889-3400/425-889-3617
Cage: 0STM5
Ingredients
NAPHTHA, MEDIUM ALIPHATIC
CAS: 64742-88-7
Fraction By Weight: 100% %
Hazards
LD50 LC50 Mixture:ORAL RAT LD50 IS UNKNOWN; TLV 100 PPM
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:LIQUID IS PRACTICALLY NON-IRRITATING
TO EYES. LIQUID SLIGHTLY IRRITATING TO THE SKIN. REPEATED USE MAY
RESULT IN DRYNESS OF THE SKIN AND DERMATITIS. INHALATION MAY RESULT
IN IRRITATION OF THE NOSE, TH ROAT AND RESPIRATORY TRACT. HIGH
CONCENTRATIONS MAY RESULT IN CNS DEPRESSION. INGESTION: ASPIRATION
HAZARD.
Explanation of Carcinogenicity:THIS COMPOUND CONTAINS NO INGREDIENTS AT
CONCENTRATIONS OF 0.1% OR GREATER THAT ARE CARCINOGENS OR SUSPECT
CARCINOGENS.
Effects of Overexposure:MAY CAUSE EYE, SKIN & RESPIRATORY TRACT
IRRITATION. MAY ALSO CAUSE HEADACHE, DIZZINESS AND NAUSEA.
ASPIRATION PNEUMONITIS MAY CAUSE COUGHING, LABORED BREATHING, IN
SEVERE CASES, DEATH.
Medical Cond Aggravated by Exposure:PERSONS WITH PRE-EXISTING DISEASES
INVOLVING THE SKIN, EYE OR RESPIRATORY SYSTEM MAY BE AT INCREASED
RISK FROM EXPOSURE.
First Aid
First Aid:EYES: FLUSH WITH RUNNING WATER FOR 15 MINUTES WHILE HOLDING
EYELIDS OPEN. GET MEDICAL ATTENTION IMMEDIATELY. SKIN: WASH WITH
SOAP AND WATER. REMOVE CONTAMINATED CLOTHING. GET MEDICAL ADVICE.
INHALATIO N: REMOVE TO FRESH AIR. GIVE MOUTH-TO-MOUTH RESUSCITATION
IF NOT BREATHING. GET MEDICAL ATTENTION. INGESTION: DO NOT INDUCE
VOMITING. RINSE MOUTH & DRINK LARGE AMOUNTS OF WATER. GET MEDICAL
ATTENTION.
Fire Fighting
Flash Point Method:TCC
Flash Point:141-145F
Lower Limits:1 %
Upper Limits:7 %
Extinguishing Media:USE WATER FOG, CARBON DIOXIDE, FOAM, OR DRY
CHEMICAL. DO NOT USE A DIRECT STREAM OF WATER.
Fire Fighting Procedures:WEAR FIRE FIGHTING PROTECTIVE EQUIPMENT AND A
FULL FACED SELF CONTAINED BREATHING APPARATUS. COOL FIRE EXPOSED
CONTAINERS WITH WATER SPRAY.
Unusual Fire/Explosion Hazard:PRODUCT WILL FLOAT AND CAN BE IGNITED ON
SURFACE OF WATER. COMBUSTIBLE.
Accidental Release
Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. WEAR
APPROPRIATE RESPIRATOR AND OTHER PROTECTIVE CLOTHING. DIKE AHEAD
AND CONTAIN. REMOVE WITH VACUUM TRUCKS OR PUMP. SOAK UP RESIDUE
WITH ABSORBENT SUCH AS CLAY, SAND OR OTHER SUITABLE MAYTERIAL.
PLACE IN CONTAINERS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP LIQUID AND VAPOR AWAY FROM HEAT,
SPARKS, AND FLAME. SURFACES THAT ARE SUFFICIENTLY HOT MAY IGNITE
EVEN LIQUID PRODUCT IN ABSENCE OF SPARKS.
Other Precautions:EXTINGUISH PILOT LIGHTS, CIGARETTES AND TURN OFF
OTHER SOURCES OF IGNITION PRIOR TO USE AND UNTIL ALL VAPORS ARE
GONE. VAPORS MAY ACCUMULATE AND TRAVEL TO IGNITION SOURCES DISTANT
FROM HANDLING SITE. BOND AND GROUND TRANSFER EQUIPMENT.
Exposure Controls
Respiratory Protection:IF VENTILATION DOES NOT MAINTAIN INHALATION
EXOSURES BELOW PEL (TLV), USE NIOSH/MSHA APPROVED RESPIRATOR AS PER
CURRENT 29 CFR 1910.134, INSTRUCTIONS/WARNINGS AND NIOSH RESPIRATOR
SELECTION.
Ventilation:EXPLOSION-PROOF LOCAL AND MECHANICAL(GENERAL) EXHAUST TO
PROVIDE ADEQUATE VENTILATION.
Protective Gloves:CHEMICAL RESISTANT GLOVES EG NITRILE
Eye Protection:SAFETY GLASSES - CHEMICAL SPLASH GOGGLES
Other Protective Equipment:WEAR INDUSTRIAL WORK CLOTHING. USE RUBBER
APRON OR BOOTS IF NEEDED. HAVE EMERGENCY EYE WASH AND SAFETY SHOWER
AVAILABLE.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING AND BEFORE
EATING, DRINKING OR SMOKING. LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
AVOID PROLONGED OR REPEATED EXPOSURE. DO NOT GET ON SKIN OR IN EYES. DO
NOT BREATHE VAPORS OR MIST. DO NOT INGEST. READ PRECAUTIONS ON
LABEL BEFORE USE.
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:361-441F
Melt/Freeze Pt:M.P/F.P Text:NOT GIVEN
Vapor Pres:5 @ 100F
Vapor Density:5.3
Spec Gravity:0.78-0.806
Evaporation Rate & Reference:0.03 (BUTYL ACETATE=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:LIGHT COLORED LIQUID, HYDROCARBON ODOR
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:HIGH HEAT, OPEN FLAMES AND OTHER SOURCES
OF IGNITION
Hazardous Decomposition Products:CARBON MONOXIDE AND UNIDENTIFIED
ORGANIC COMPOUNDS MAY BE FOMED DURING COMBUSTION.
Disposal
Waste Disposal Methods:DISPOSAL OF WASTE AND HAZARDOUS MATERIAL SHALL
COMPLY WITH LOCAL, STATE AND FEDERAL ENVIRONMENTAL PROTECTION
AGENCY REGULATIONS. SEND WASTE MATERIAL TO AN APPROVED RECYCLING
FACILITY IF FEASIBLE. CITY , STATE AND FEDERAL REGULATIONS MUST
BEFOLLOWED.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.